You push the door shut and it catches on the frame. You lift the handle slightly, and it latches. Sooner or later, it won't latch at all.
A sagging door is one of the most common door problems, and it rarely fixes itself. The good news is that the cause is usually simple, and the repair often takes under an hour.
This guide explains why doors sag, how to fix them, and how to choose door hinges that hold up for the long run.
Signs Your Door Is Sagging
- The door rubs against the frame, usually at the top corner on the latch side.
- The latch no longer lines up with the strike plate.
- The gap along the top of the door is uneven, wider on one side than the other.
- You have to lift or push the door to close it.
- The hinges look loose, bent, or shifted away from the frame.
- You can see light or feel air along one edge of the door.
Why Doors Sag
1. Loose or stripped screws
Every time the door opens and closes, the hinge screws carry the full weight of the door. Over time, the screw holes in the wood wear out and the screws lose their grip.
2. Worn hinges
Hinges have moving parts. On a busy door, the pin and knuckles wear down, which lets the door drop slightly out of position.
3. Hinges too light for the door
A heavy solid-core or exterior door on a light-duty hinge will sag. The hinge wasn't built to carry that load.
4. Too few hinges
A tall or heavy door usually needs three hinges instead of two. The middle hinge shares the load and keeps the door from bowing.
5. Frame or door movement
Changes in humidity and temperature can make wood swell and shift, and a settling house can pull the frame out of square.
How to Fix a Sagging Door
Work through these steps in order. Many doors are fixed by the first or second one.
- Tighten every hinge screw. Use a screwdriver, not a power drill on high torque, so you don't strip the holes further.
- Replace stripped screws. Swap the short screws on the frame side with 2.5 to 3 inch screws that reach through the jamb into the wall framing. This pulls the door back into position and gives the hinge a much stronger hold.
- Fill damaged screw holes. If the holes are badly worn, insert wood glue and a few wooden toothpicks or a dowel, trim flush, and re-drive the screws once it dries.
- Check the hinges themselves. If a hinge is bent, loose at the pin, or visibly worn, replace it rather than tightening it again.
- Upgrade the hinge if needed. If the door is heavy or used constantly, step up to a heavy-duty hinge and add a third hinge if the door has only two.
- Test the door. It should swing freely, close without rubbing, and latch without lifting.
Tip: Replace hinges one at a time. That way the door stays supported and aligned while you work.
Common Types of Door Hinges
| Hinge Type | How It Works | Typically Used For |
|---|---|---|
| Butt hinge | Two leaves joined by a pin, mounted in a recess on the door edge and frame | Interior and exterior doors of all kinds |
| Concealed hinge | Mounted inside the door and frame, hidden when the door is closed | Clean, modern look where the hinge should not show |
| Continuous (piano) hinge | Runs the full length of the door edge | High-traffic and heavy doors that need even support |
| Strap or T-hinge | Long decorative or reinforced leaf mounted on the door face | Gates, barn-style doors, and utility doors |
| Pivot hinge | Door pivots on a top and bottom point instead of the side | Very heavy or oversized doors |
What to Look for When Choosing a Door Hinge
- Load capacity. Match the hinge to the weight of the door. Heavier doors need heavier hinges.
- Material. Steel, stainless steel, and zinc alloy hold up well. Pick a material that resists rust if the door is exposed to moisture.
- Size. Measure the height and width of the existing hinge, and check the screw hole spacing so the new hinge lines up with the old mortise.
- Number of hinges. Doors over about 60 inches tall, or any heavy door, generally perform better with three hinges.
- Finish. Match the color to your door and the rest of your hardware.
- Door traffic. A busy entry needs a sturdier hinge than a closet door.
If you want a hidden look with solid construction, take a look at our concealed door hinges, which are available in several colors.
Keep the Rest of the Door in Shape Too
Once the door hangs straight again, the rest of the opening works better as well. A door that no longer drops can finally seal properly against a threshold, and a new door bottom or sweep will block drafts without dragging on the floor. If you have double doors, a T-astragal closes the center gap once both doors are aligned.
FAQ
Why is my door sagging even though I tightened the screws?
The screw holes may be stripped, or the hinge may be worn or too light for the door. Try longer screws that reach the wall framing, and replace the hinge if it is bent or loose at the pin.
How many hinges does a door need?
Most standard interior doors use two or three. Taller, heavier, or exterior doors generally do better with three, because the extra hinge shares the load and keeps the door from bowing.
Can I replace door hinges myself?
Yes. If the new hinge matches the size and screw pattern of the old one, you only need a screwdriver or drill. Replace one hinge at a time so the door stays aligned.
How do I measure a door hinge for replacement?
Measure the height of the hinge leaf, the width when opened flat, and the distance between screw holes. Bringing the old hinge with you or comparing photos makes matching easier.
What is the best hinge for a heavy door?
A heavy-duty hinge made of steel, stainless steel, or strong zinc alloy, with a load rating that matches your door. Adding a third hinge also helps spread the weight.
Will new hinges stop my door from rubbing the frame?
If worn or loose hinges are the cause, yes. If the frame has shifted or the door has swollen from moisture, you may also need to adjust the frame or plane the door edge.
Have more questions? Visit our full FAQ page.
Final Thoughts: A Straight Door Starts With Good Hinges
A sagging door is a sign that the hinges are doing more work than they were built for. Tighten, reinforce, or replace them early, and the door will close easily and last far longer.
Choose hinges that fit the weight, traffic, and exposure of your door, and you will not have to think about them again for years.
